"ZV" adjustable flow indicators permit a reed micro switch actuation upon reaching a preset flow value. The set point is reached by sliding the Din-housing towards the direction of flow to increase the flow signal value and against the direction of flow to decrease the flow signal value.
It can work with different types of fluids and gases without dirt or impurities. We recommend the use of filters installed before the instruments.

Technical Features:
Body in anodized aluminum
Installation position: the flow monitor must be installed vertically in the fluid circuit, with flow direction from down to up.
Minimum distance from inductive fields, magnet, and iron parts: 30 mm
Working temperature: from -20°C to+100°C

Electric Features:
Electrical connection according to
DIN 43650
Electrical protection according to
DIN 40050: IP65
Electrical contacts: NA standard
Maximum contact load:
Alternating current up to 48 Volts - 1 Amp
Direct current up to 48 Volts – 0.5 Amp

Also Available
AISI 316 stainless steel body.
Body in brass.
Nickel-plated brass body.

We reserve the right to make construction modifications without prior notice.